Rebutia patericalyx

Synonyms:

Aylostera deminuta var. pseudominuscula
Aylostera froehlichiana
Aylostera fulviseta
Aylostera fusca
Aylostera mamillosa
Aylostera patericalyx
Aylostera pseudodeminuta
Aylostera sumayana
Aylostera tarvitaensis
Aylostera vulpina
Aylostera zecheri
Echinocactus pseudominusculus
Echinopsis pseudominuscula
Lobivia atrovirens var. zecheri
Rebutia deminuta subsp. pseudominuscula
Rebutia froehlichiana
Rebutia fusca
Rebutia mamillosa

Habitat:

Rebutia patericalyx is native to Argentina Northwest and Bolivia.

Description:

Rebutia patericalyx is a small succulent belonging to the Cactaceae botanical family. The plant can be single-stemmed to sparsely clustering and can reach up to 3 cm in diameter. The stem is short, globular to oval, with the apex depressed and dark green in color, arranged in 13-16 ribs. The areoles are small, woolly, whitish to greyish and bear the spines. The 12-14 spines are short, spreading laterally, pale yellow to white in color. Blooming occurs in early summer and the blossoms are borne near the apex of the stem. The flowers are funnel-shaped, covered outside and inside with greyish woolly and they are made of many petals. The flowers are bright orange to scarlet in color and the stamens are yellow and are located at the center of the flower.

Cultivation:

The plant grows very slowly but it is easy to cultivate. The plant needs a full light sun exposure but is recommended to avoid direct sun-light during the summer. Long exposure to direct sun-light can cause burns and burnt spots. The succulent can tolerate temperatures to 45° C, and short periods of frost, but prolonged cold will damage or kill the plant. Too low temperatures can cause the stem or leaves to break due to water freezing inside the tissues. Temperatures between 10 and 15 °C allow the plants to enter vegetative rest which is essential for the flowering of the following year. Plants should not be placed inside the house where average temperatures of 20 degrees prevent vegetative rest. The best draining soil for this genus is made up of 40% fertile loam, 40% pumice and 20% coarse sand. The pumice should always be placed on the bottom of the pot. Remember to use a perforating pot to drain excess water. Watering can be done regularly during the vegetative period. During the vegetative period you can water the plant every 5 days with half a glass of water, checking that the soil is completely dry before watering again; in winter you should stop the watering to allow the plant to enter dormancy. Decrease the amount of water if the plant is kept indoors or if the pot is smaller than 12 cm. The plant must be fed with a high potassium fertilizer in the summer. You can dilute the fertilizer twice a month in the irrigation water. If the pot starts to be too small for the plant you can repot the plant in a pot 2 cm wider. Repotting should be done early in the growing season with fresh new potting soil; it is usually done every year until the plant reaches 13 cm in diameter. Be careful to red spiders and mealy bugs.

Propagation:

Propagation can be done by seed, cutting or grafting. By cutting you can make the cut during the spring and then let the cutting dry; after a few days the cut surface will dry and a callus will form, then place the cutting in a mixture of sand, soil and pumice. To increase the success of propagation you can make two or more cuttings at the same time. It is advisable to use rooting hormone at the base of the cut to energize root development. For cuttings it is recommended temperatures around 20 °C. By seed it is very simple to propagate the plant, it is enough to sow the seed in a sandy loam and keep it with a high level of humidity and at temperature of 14 C°. By grafting make the cut as close to the growing tip as possible, then chose a stock with a diameter similar to that of the scion. After the cut, wash away the latex until it no longer remains. Bring the scion closer to the stock and held together with elastic bands. The plants should be left in an airy and shady place for 7-10 days before the bands are removed.

Curiosity:

Although they have been identified as a genus since the late 1800s, the classification of Rebutia is still being discussed, given their proximity to other genus of dwarf cacti. The name of the species comes from Latin and literally means “goblet shaped like a bowl”, referring to the look of its ample scarlet flowers.

Official Web Site:
www.giromagi.com

Italian Blog:
www.giromagicactus.com

Tips:
Read our advice

Recent Posts

Start typing and press Enter to search